West Bend Just For Dinner Breadmaker Spezifikationen PDF herunterladen (Seite 10)

Unplug cord fiom electrical outlet and allow bread maker to cool before cleaning.

The bread pan and kalead bar must be cleaned after each use to ensure perforlnance. After bread is relnoved from pan, fill pan

half full with warm water and small amount of dish soap. Set pan in empty sink or on hot pad and allow to soak for 5 to 10

minutes or until kalead bar can be lifted off shaft. Twist bar slightly to loosen. The kalead bar must soak in water before it can

be relnoved. Wash inside of pan and knead bar with a soft cloth, rinse and dry. Replace bar on shaft.

Be sure that shaft in pan is kept clean so that kalead bar fits properly. DO NOT use any type of utensil or tool to clean the gasket

around the shaft as damage will occur and result in leakage. DO NOT use any abrasive scouring pads or cleansers on bread pan or

kalead bar as damage to finish can occur. The coating inside of bread pan may change color over time, which is normal and does not

affect the bread or dough. CAUTION: To prevent personal injury or electric shock, do not immerse bread maker base, its cord or

plug in water or other liquid.

3. Wipe inside of chamber and outside surthces of bread maker with a damp cloth if necessary. The cover is relnovable for

cleaning if needed. Simply open it 45 degrees and pull toward you. Wipe cover with a damp, soapy cloth and dry. DO NOT

immerse cover in water or place in automatic dish,a_asher as water will get in between the parts and cause damage.

Replace cover by aligning attachment hooks into hinge on back of bread maker. Cover should move fieely up and do,a_ after being

replaced. See "Parts of Bread Maker".

OTHER HELPFUL TIPS FOR USING YOUR BREADMAKER

1. BE SURE to allow adequate ventilation around the bread maker when it is in operation. Keep it out of drafts and direct sunlight and

at least tour (4) inches away from walls, cabinets and other appliances, especially heating and cooling appliances which interfere with

the internal bread maker temperatures and affect the loaf of bread being prepared.

2. ALWAYS place bread maker on a DRY, STABLE heat-proof countertop or table during use. Since the bread maker contains a

motor, some vibration occurs during the kalead cycle.

3. DO NOT cover bread maker with anything during operation as this can cause malfunction.

4. DO NOT TOUCH control panel buttons after bread maker has been turned on as this can interrupt the cycle. Turn bread maker off

after completion of cycle.

5. DO NOT LEAVE bread maker plugged into electrical outlet when not in use to prevent it fiom being accidentally turned on.

BREAKDOWN OF BREAD/DOUGH CYCLES - To help you understand the bread making process, the following chart breaks

down each cycle's time in minutes and seconds. These times are approxilnate and should be used only as a guide. The total process

time is given in hours and minutes, depending on the crust selection made.

BREAKDOWN OF BASIC/SPECIALTY WHOLE WHEAT DOUGH

BREAD /DOUGH

CYCLES

MIX 5 min. 5 min. 5 rain.

REST 15min. 15 min. 0 min.

KNEAD 20 min. 30 min. 20 min.

RISE (1) 34 min. 50 min. 55 min.

STIR-DOWN (1) 16 sec. 16 sec. 16 sec.

RISE (2) 15 min. 14 min.

STIR-DOWN (2) 16 sec. 16 sec.

RISE (3) 50 min. 55 min.

BAKE (LIGHT) 40 min. 40 rain.

(MEDIUM) 50 min. 50 rain.

(DARK) 60 min. 60 min.

Total Time (Hour- 1:20

Minutes)

(LIGHT) 3:00 3:30

(MEDIUM) 3:10 3:40

(DARK) 3:20 3:50

REGULAR BREAD AND DOUGH CYCLES

MIX When turned on, the bread maker mixes ingredients about 5 minutes. The knead bar will start and stop during mixing.

Rest The dough is allowed to rest about 15 minutes bel\3re kaleading, fhint clicking sounds indicate the bread maker is keeping the

dough warm.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Kommentare zu diesen Handbüchern

Keine Kommentare

West Bend Just For Dinner Breadmaker Spezifikationen Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Brotbackmaschinen West Bend Just For Dinner Breadmaker